Flexible Heavy-Duty Coating

• ENVIRONMENTALLY FRIENDLY - Liquid Rubber Driveway Restore Sealer is water based, containing no Solvents or VOC's. This means it's safe to use with no special breathing apparatus like solvenated products need. You're safe, your children are safe and your pets are safe. We believe you should have a choice in purchasing high quality products that are safe for you and the environment
• USED FOR: Revitalizing your aging, weathered asphalt driveway
• See ASPHALT DRIVEWAY APPLICATION page for more specific info
• EASY TO APPLY - Basically just like painting except you use heavy coats to build up your waterproof membrane. Open the container and start using. You can close the container and use later if you have left over material. No pot life or working time like 2 component products.
  Apply by Brush, Roller or Foam Squeegee.
• HIGHLY FLEXIBLE - UV Stable - Driveway Restore will withstand weathering and not degrade due to UV.

Asphalt Surface

Apply a minimum final thickness of 1 gallon per 50 sq ft (4.65 sq/m). It should require around 2-3 coats.

Tips

• Apply using an 18" foam squeegee or push-broom. (Use a
  6- 12" brush for edges.)
• Apply to dry surface that is free of dirt, loose paint, rust, oil, grease, coal tar, silicone, or other contaminants.
• Apply when temperature is above 5ºC/41°F and rising.
• Use Liquid Rubber Deck and Patio Cleaner to clean.
• Apply each coat in an alternate direction to the last coat to ensure even coverage.
• Apply final coat in the direction of slope for positive drainage.
• Apply next coat when dry to the touch with nothing wet underneath and is uniform in color. (typically 12 hours)
• Avoid hot, direct, intense sun when applying.
• Avoid contact with solvents and solvent based cleaners, adhesives, and paints.
• Do not allow to freeze.
• Do not apply in wet conditions (including fog and dew) or if rain is forecasted within 24 hours.
• Curing time depends on temperature, humidity and airflow.
• Initial cure(set) within 48 hours or until completely dry and drivable.
• Full cure in 5-7 days.
• Make sure what you’re coating is at least 5 degrees above the dew point of the environment you are coating in. (See technical specs for more details)
• For best results remove existing paints/coatings and apply directly to the substrate. (Some paints and coatings will not be compatible. Loose/flaky paint may be an indication that the existing paint/coating is not well bonded and therefore your Liquid Rubber solution may fail if applied over it instead of directly to the substrate. Oil based paints, enamels, epoxies, powder coats can be difficult to bond to. Contact your Liquid Rubber technical representative for further direction.)
• Wrap brushes in plastic and refrigerate to use for next coat.
• Remove painters tape/blocking while coating is still wet.

• Asphalt Driveway Restore - Double Driveway
• Asphalt Driveway Restore - Single Driveway

• Liquid Rubber Driveway Restore Application Guideline
• Liquid Rubber Driveway Restore Data Sheet
• Liquid Rubber Driveway Restore SDS